3D Printed Backflow Incense Burner

Approximately 6 Inches Tall | Fully Color Customizable | Backflow Incense Bundle

Turn incense burning into part of the décor with our 3D Printed Backflow Incense Burners! Each burner is printed with attention to detail and designed specifically for use with backflow incense cones, allowing the smoke to travel downward and flow through the design for a beautiful cascading smoke effect.

YOUR BUNDLE INCLUDES

• One 3D Printed Backflow Incense Burner

• One Mystery Box of Backflow Incense Cones

• One 16mm Heat-Resistant Ceramic Washer

IMPORTANT: The included ceramic washer MUST be used every time you burn incense with this product.

FULLY COLOR CUSTOMIZABLE

Want something different from the colors pictured? We can customize your burner!

Because these pieces are 3D printed, you can choose colors that better match your décor, altar space, favorite aesthetic, or personal style. Please select or provide your color preferences when ordering.

HOW TO USE YOUR BACKFLOW BURNER

Only use BACKFLOW incense cones with this burner. Standard incense cones will not create the backflow smoke effect.

1. Place your backflow burner on a stable, heat-safe surface away from drafts.

2. Light the tip of your backflow incense cone.

3. Allow the flame to burn briefly, then gently blow it out so the cone begins to smolder.

4. Place the included ceramic washer over the opening at the top of the burner.

5. Place the lit backflow cone directly onto the ceramic washer, aligning the bottom opening of the cone with the opening in the washer and burner.

6. Allow approximately one minute for the cone to heat and the backflow effect to begin.

7. As the cone burns, smoke will begin flowing downward through the bottom of the cone and into the burner, creating the cascading backflow effect.

⚠️ IMPORTANT FIRE & HEAT SAFETY

THE CERAMIC WASHER MUST BE USED EVERY TIME.

The ceramic washer creates a heat-resistant barrier between the burning incense cone and the 3D printed filament.

Never place a burning or hot incense cone directly onto the 3D printed surface.

Excessive heat or burning embers that come into direct contact with the filament can cause the burner to warp, melt, become damaged, or potentially create a fire hazard.

• Never leave burning incense unattended.

• Always use the included ceramic washer.

• Use only backflow incense cones.

• Always place the burner on a stable, heat-resistant surface.

• Keep away from drafts, curtains, paper, and other flammable materials.

• Watch for falling ash or hot embers and remove them from the printed surface immediately.

• Keep away from children and pets.

• Allow the burner and ceramic washer to cool completely before touching, cleaning, or moving them.

• Never allow a burning cone or ember to come into direct contact with the 3D printed filament.

ABOUT 3D PRINTED PRODUCTS

Each burner is individually 3D printed rather than mass-produced. Small variations are a normal part of the 3D printing process and make each piece uniquely yours.

You may notice subtle layer lines, tiny surface variations, seams, or minor differences in texture. These are normal characteristics of FDM 3D printing and are not considered defects.

Colors may also vary slightly from photographs due to filament batches, lighting, monitor settings, and the natural appearance of specialty or silk filaments.

PLEASE NOTE

This product is intended to be used as an incense burner only when the included heat-resistant ceramic washer is properly positioned between the burning backflow cone and the 3D printed surface.

Never expose the printed filament directly to flame, burning incense, hot embers, or other high-heat sources.

Handmade & 3D Printed by Two Sisters of the Harvest Moon